| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
mm/mincore: handle non-swap entries before !CONFIG_SWAP guard
mincore_swap() also fields migration/hwpoison entries (and shmem
swapin-error entries), which can exist on !CONFIG_SWAP builds when
CONFIG_MIGRATION or CONFIG_MEMORY_FAILURE is enabled. The
!IS_ENABLED(CONFIG_SWAP) guard ran before the non-swap-entry early return,
so mincore_pte_range() can spuriously WARN and report these pages
nonresident on !CONFIG_SWAP kernels.
Move the guard below the non-swap-entry check so only true swap entries
trip the WARN, and migration/hwpoison entries take the existing "uptodate
/ non-shmem" path. |
| In the Linux kernel, the following vulnerability has been resolved:
ARM: 9475/1: entry: use byte load for KASAN VMAP stack shadow
Commit 44e9a3bb76e5 ("ARM: 9430/1: entry: Do a dummy read from
VMAP shadow") added a dummy read from the KASAN VMAP stack shadow in
__switch_to(). The read uses ldr, but the KASAN shadow address is
byte-granular and is not guaranteed to be word aligned.
ARMv5 faults unaligned word loads. With CONFIG_KASAN_VMALLOC and
CONFIG_VMAP_STACK enabled, ARM926/VersatilePB crashes in __switch_to()
with an alignment exception before reaching init.
Use ldrb for the dummy shadow access. The code only needs to fault in the
shadow mapping if the stack shadow is missing, so a byte load is sufficient
and matches the granularity of KASAN shadow memory. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/virtio: Fix driver removal with disabled KMS
DRM atomic and modesetting aren't initialized if virtio-gpu driver built
with disabled KMS, leading to access of uninitialized data on driver
removal/unbinding and crashing kernel. Fix it by skipping shutting down
atomic core with unavailable KMS. |
| In the Linux kernel, the following vulnerability has been resolved:
slimbus: qcom-ngd-ctrl: Avoid ABBA on tx_lock/ctrl->lock
During the SSR/PDR down notification the tx_lock is taken with the
intent to provide synchronization with active DMA transfers.
But during this period qcom_slim_ngd_down() is invoked, which ends up in
slim_report_absent(), which takes the slim_controller lock. In multiple
other codepaths these two locks are taken in the opposite order (i.e.
slim_controller then tx_lock).
The result is a lockdep splat, and a possible deadlock:
rprocctl/449 is trying to acquire lock:
ffff00009793e620 (&ctrl->lock){+.+.}-{4:4}, at: slim_report_absent (drivers/slimbus/core.c:322) slimbus
but task is already holding lock:
ffff00009793fb50 (&ctrl->tx_lock){+.+.}-{4:4}, at: qcom_slim_ngd_ssr_pdr_notify (drivers/slimbus/qcom-ngd-ctrl.c:1475) slim_qcom_ngd_ctrl
which lock already depends on the new lock.
Possible unsafe locking scenario:
CPU0 CPU1
---- ----
lock(&ctrl->tx_lock);
lock(&ctrl->lock);
lock(&ctrl->tx_lock);
lock(&ctrl->lock);
The assumption is that the comment refers to the desire to not call
qcom_slim_ngd_exit_dma() while we have an ongoing DMA TX transaction.
But any such transaction is initiated and completed within a single
qcom_slim_ngd_xfer_msg().
Prior to calling qcom_slim_ngd_exit_dma() the slim_controller is torn
down, all child devices are notified that the slimbus is gone and the
child devices are removed.
Stop taking the tx_lock in qcom_slim_ngd_ssr_pdr_notify() to avoid the
deadlock. |
| In the Linux kernel, the following vulnerability has been resolved:
riscv/ptrace: Use USER_REGSET_NOTE_TYPE for REGSET_CFI
Fixes a warning while dumping core:
[54983.546369][ C7] WARNING: [!note_name] fs/binfmt_elf.c:1771 at elf_core_dump+0x910/0xf68, CPU#7: abort01/31982 |
| In the Linux kernel, the following vulnerability has been resolved:
sched_ext: Don't warn on NULL cgrp_moving_from in scx_cgroup_move_task()
A WARN fires when systemd's user manager writes "+cpu +memory +pids" to
its own subtree_control while a sched_ext scheduler is loaded:
WARNING: at kernel/sched/ext.c:3227 scx_cgroup_move_task+0xa8/0xb0
scx_cgroup_move_task+0xa8/0xb0
sched_move_task+0x134/0x290
cpu_cgroup_attach+0x39/0x70
cgroup_migrate_execute+0x37d/0x450
cgroup_update_dfl_csses+0x1e3/0x270
cgroup_subtree_control_write+0x3e7/0x440
scx_cgroup_can_attach() arms cgrp_moving_from only when a task's cpu
cgroup changes. It can still be NULL when scx_cgroup_move_task() runs,
through this sequence:
Step Result
--------------------------------- ----------------------------------
1. cpu enabled on cgroup G cpu css = A
2. cpu toggled off then on for G A killed, B created (same cgroup)
3. an exiting task keeps A alive migration skips it, A now stale
4. +memory migrates G stale A vs current B pulls cpu in
5. cpu attach runs for all tasks hits a live, cpu-unchanged task
6. scx_cgroup_move_task() on it cgrp_moving_from NULL -> WARN
The mismatch is that scx_cgroup_can_attach() keys on cgroup identity
while migration drives the move on css identity, so a NULL cgrp_moving_from
here is a legitimate css-only migration, not a missing prep.
The call is already gated on cgrp_moving_from, so just drop the warning.
ops.cgroup_prep_move() and ops.cgroup_move() stay paired. |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: imx: fix clock and pinctrl state inconsistency in runtime PM
In i2c_imx_runtime_suspend(), the clock is disabled before switching
the pinctrl state to sleep. If pinctrl_pm_select_sleep_state() fails,
the runtime suspend is aborted but the clock remains disabled, causing
a system crash when the hardware is subsequently accessed.
Fix this by switching the pinctrl state before disabling the clock so
that a pinctrl failure leaves the clock enabled and the hardware
accessible.
In i2c_imx_runtime_resume(), restore the pinctrl state back to sleep
if clk_enable() fails to keep the consistent. |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: qcom-cci: Fix NULL pointer dereference in cci_remove()
On all modern platforms Qualcomm CCI controller provides two I2C masters,
and on particular boards only one I2C master may be initialized, and in
such cases the device unbinding or driver removal causes a NULL pointer
dereference, because cci_halt() is called for all two I2C masters, but
a completion is initialized only for the single enabled master:
% rmmod i2c-qcom-cci
Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
<snip>
Call trace:
__wait_for_common+0x194/0x1a8 (P)
wait_for_completion_timeout+0x20/0x2c
cci_remove+0xc4/0x138 [i2c_qcom_cci]
platform_remove+0x20/0x30
device_remove+0x4c/0x80
device_release_driver_internal+0x1c8/0x224
driver_detach+0x50/0x98
bus_remove_driver+0x6c/0xbc
driver_unregister+0x30/0x60
platform_driver_unregister+0x14/0x20
qcom_cci_driver_exit+0x18/0x1008 [i2c_qcom_cci]
.... |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: SDCA: fix NULL pointer dereference in sdca_dev_unregister_functions
sdca_dev_unregister_functions() iterates over all SDCA function
descriptors and calls sdca_dev_unregister() on each func_dev without
checking for NULL. When a function registration has failed partway
through, or the device cleanup races with probe deferral, func_dev
entries may be NULL, leading to a kernel oops:
BUG: kernel NULL pointer dereference, address: 0000000000000040
RIP: 0010:device_del+0x1e/0x3e0
Call Trace:
sdca_dev_unregister_functions+0x37/0x60 [snd_soc_sdca]
release_nodes+0x35/0xb0
devres_release_all+0x90/0x100
device_unbind_cleanup+0xe/0x80
device_release_driver_internal+0x1c1/0x200
bus_remove_device+0xc6/0x130
device_del+0x161/0x3e0
device_unregister+0x17/0x60
sdw_delete_slave+0xb6/0xd0 [soundwire_bus]
sdw_bus_master_delete+0x1e/0x50 [soundwire_bus]
...
sof_probe_work+0x19/0x30 [snd_sof]
This was observed on a Lenovo ThinkPad X1 Carbon G14 (Panther Lake)
with the SOF audio driver probe failing due to missing Panther Lake
firmware, causing the subsequent cleanup of SoundWire devices to
trigger the crash.
Fix this with three changes:
1) Add a NULL guard in sdca_dev_unregister() so that callers do not
need to pre-validate the pointer (defense in depth).
2) In sdca_dev_unregister_functions(), skip NULL func_dev entries
and clear func_dev to NULL after unregistration, making the
function idempotent and safe against double-invocation.
3) In sdca_dev_register_functions(), roll back all previously
registered functions when a later one fails, so the function
array is never left in a partially-populated state. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/damon/reclaim: handle ctx allocation failure
Patch series "mm/damon/{reclaim,lru_sort}: handle ctx allocation failures".
DAMON_RECLAIM and DAMON_LRU_SORT could dereference NULL pointers if their
damon_ctx object allocations fail. The bugs are expected to happen
infrequently because the allocations are arguably too small to fail on
common setups. But theoretically they are possible and the consequences
are bad. Fix those.
The issues were discovered [1] by Sashiko.
This patch (of 2):
DAMON_RECLAIM allocates the damon_ctx object for its kdamond in its init
function. damon_reclaim_enabled_store() wrongly assumes the allocation
will always succeed once tried. If the damon_ctx allocation was failed,
therefore, code execution reaches to damon_commit_ctx() while 'ctx' is
NULL. As a result, it dereferences the NULL 'ctx' pointer. Avoid the
NULL dereference by returning -ENOMEM if 'ctx' is NULL. |
| Race in DataTransfer in Google Chrome prior to 150.0.7871.47 allowed a remote attacker to obtain potentially sensitive information from process memory via a crafted HTML page. (Chromium security severity: Medium) |
| Use after free in Bluetooth in Google Chrome prior to 150.0.7871.47 allowed an attacker on the local network segment to obtain potentially sensitive information from process memory via a malicious peripheral. (Chromium security severity: Medium) |
| In the Linux kernel, the following vulnerability has been resolved:
pinctrl: mcp23s08: Initialize mcp->dev and mcp->addr before regmap init
Regmap initialization triggers regcache_maple_populate() which attempts
SPI read to populate cache. SPI read requires mcp->dev and mcp->addr to
be set, without them, NULL pointer dereference occurs during probe.
Move initialization before mcp23s08_spi_regmap_init() call. |
| In the Linux kernel, the following vulnerability has been resolved:
net: airoha: Add NULL check for of_reserved_mem_lookup() in airoha_qdma_init_hfwd_queues()
of_reserved_mem_lookup() may return NULL if the reserved memory region
referenced by the "memory-region" phandle is not found in the reserved
memory table (e.g. due to a misconfigured DTS or a removed
memory-region node). The current code dereferences the returned
pointer without checking for NULL, leading to a kernel NULL pointer
dereference at the following lines:
dma_addr = rmem->base; // line 1156
num_desc = div_u64(rmem->size, buf_size); // line 1160
Add a NULL check after of_reserved_mem_lookup() and return -ENODEV if
the lookup fails, which is consistent with the existing error handling
for of_parse_phandle() failure in the same code block. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/damon/lru_sort: handle ctx allocation failure
DAMON_LRU_SORT allocates the damon_ctx object for its kdamond in its init
function. damon_lru_sort_enabled_store() wrongly assumes the allocation
will always succeed once tried. If the damon_ctx allocation was failed,
therefore, code execution reaches to damon_commit_ctx() while 'ctx' is
NULL. As a result, it dereferences the NULL 'ctx' pointer. Avoid the
NULL dereference by returning -ENOMEM if 'ctx' is NULL. |
| Side-channel information leakage in CSS in Google Chrome prior to 150.0.7871.47 allowed a remote attacker to obtain potentially sensitive information from process memory via a crafted HTML page. (Chromium security severity: Medium) |
| Inappropriate implementation in SplitView in Google Chrome on Linux prior to 150.0.7871.47 allowed a remote attacker who convinced a user to engage in specific UI gestures to spoof the contents of the Omnibox (URL bar) via a crafted HTML page. (Chromium security severity: Low) |
| IBM Db2 11.5.0 through 11.5.9, and 12.1.0 through 12.1.4 for Linux, UNIX and Windows (includes Db2 Connect Server) could allow an authenticated user to cause a denial of service due to improper neutralization of special elements in the data query logic of XMLTable-derived columns. |
| Incorrect security UI in SplitView in Google Chrome prior to 150.0.7871.47 allowed a remote attacker who convinced a user to engage in specific UI gestures to perform UI spoofing via a crafted HTML page. (Chromium security severity: Low) |
| Integer overflow in WebNN in Google Chrome prior to 150.0.7871.47 allowed a remote attacker to obtain potentially sensitive information from process memory via a crafted HTML page. (Chromium security severity: Low) |
