| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Wi-Fi Protected Access (WPA and WPA2) allows reinstallation of the Group Temporal Key (GTK) during the four-way handshake, allowing an attacker within radio range to replay frames from access points to clients. |
| Wi-Fi Protected Access (WPA and WPA2) that supports IEEE 802.11w allows reinstallation of the Integrity Group Temporal Key (IGTK) during the four-way handshake, allowing an attacker within radio range to spoof frames from access points to clients. |
| Wi-Fi Protected Access (WPA and WPA2) allows reinstallation of the Group Temporal Key (GTK) during the group key handshake, allowing an attacker within radio range to replay frames from access points to clients. |
| Wi-Fi Protected Access (WPA and WPA2) that supports IEEE 802.11w allows reinstallation of the Integrity Group Temporal Key (IGTK) during the group key handshake, allowing an attacker within radio range to spoof frames from access points to clients. |
| Wi-Fi Protected Access (WPA and WPA2) that supports IEEE 802.11r allows reinstallation of the Pairwise Transient Key (PTK) Temporal Key (TK) during the fast BSS transmission (FT) handshake, allowing an attacker within radio range to replay, decrypt, or spoof frames. |
| Wi-Fi Protected Access (WPA and WPA2) allows reinstallation of the Station-To-Station-Link (STSL) Transient Key (STK) during the PeerKey handshake, allowing an attacker within radio range to replay, decrypt, or spoof frames. |
| Wi-Fi Protected Access (WPA and WPA2) allows reinstallation of the Tunneled Direct-Link Setup (TDLS) Peer Key (TPK) during the TDLS handshake, allowing an attacker within radio range to replay, decrypt, or spoof frames. |
| Wi-Fi Protected Access (WPA and WPA2) that support 802.11v allows reinstallation of the Group Temporal Key (GTK) when processing a Wireless Network Management (WNM) Sleep Mode Response frame, allowing an attacker within radio range to replay frames from access points to clients. |
| Wi-Fi Protected Access (WPA and WPA2) that support 802.11v allows reinstallation of the Integrity Group Temporal Key (IGTK) when processing a Wireless Network Management (WNM) Sleep Mode Response frame, allowing an attacker within radio range to replay frames from access points to clients. |
| An issue was discovered on MOXA EDS-G512E 5.1 build 16072215 devices. The password encryption method can be retrieved from the firmware. This encryption method is based on a chall value that is sent in cleartext as a POST parameter. An attacker could reverse the password encryption algorithm to retrieve it. |
| IBM System Storage Storwize V7000 Unified (V7000U) 1.5 and 1.6 uses weaker than expected cryptographic algorithms that could allow an attacker to decrypt highly sensitive information. IBM X-Force ID: 126868. |
| On Samsung NVR devices, remote attackers can read the MD5 password hash of the 'admin' account via certain szUserName JSON data to cgi-bin/main-cgi, and login to the device with that hash in the szUserPasswd parameter. |
| Lack of Transport Encryption in the public API in Philips Hue Bridge BSB002 SW 1707040932 allows remote attackers to read API keys (and consequently bypass the pushlink protection mechanism, and obtain complete control of the connected accessories) by leveraging the ability to sniff HTTP traffic on the local intranet network. |
| The airbag detonation algorithm allows injury to passenger-car occupants via predictable Security Access (SA) data to the internal CAN bus (or the OBD connector). This affects the airbag control units (aka pyrotechnical control units or PCUs) of unspecified passenger vehicles manufactured in 2014 or later, when the ignition is on and the speed is less than 6 km/h. Specifically, there are only 256 possible key pairs, and authentication attempts have no rate limit. In addition, at least one manufacturer's interpretation of the ISO 26021 standard is that it must be possible to calculate the key directly (i.e., the other 255 key pairs must not be used). Exploitation would typically involve an attacker who has already gained access to the CAN bus, and sends a crafted Unified Diagnostic Service (UDS) message to detonate the pyrotechnical charges, resulting in the same passenger-injury risks as in any airbag deployment. |
| IBM Security Guardium 10.0 Database Activity Monitor uses weaker than expected cryptographic algorithms that could allow an attacker to decrypt highly sensitive information. IBM X-Force ID: 132611. |
| In the "NQ Contacts Backup & Restore" application 1.1 for Android, RC4 encryption is used to secure the user password locally stored in shared preferences. Because there is a static RC4 key, an attacker can gain access to user credentials more easily by leveraging access to the preferences XML file. |
| In the "NQ Contacts Backup & Restore" application 1.1 for Android, DES encryption with a static key is used to secure transmitted contact data. This makes it easier for remote attackers to obtain cleartext information by sniffing the network. |
| Citrix NetScaler Application Delivery Controller (ADC) and NetScaler Gateway 10.5 before build 67.13, 11.0 before build 71.22, 11.1 before build 56.19, and 12.0 before build 53.22 might allow remote attackers to decrypt TLS ciphertext data by leveraging a Bleichenbacher RSA padding oracle, aka a ROBOT attack. |
| The default SSH configuration in Rapid7 Nexpose hardware appliances shipped before June 2017 does not specify desired algorithms for key exchange and other important functions. As a result, it falls back to allowing ALL algorithms supported by the relevant version of OpenSSH and makes the installations vulnerable to a range of MITM, downgrade, and decryption attacks. |
| An issue was discovered in sysPass 2.x before 2.1, in which an algorithm was never sufficiently reviewed by cryptographers. The fact that inc/SP/Core/Crypt.class is using the MCRYPT_RIJNDAEL_256() function (the 256-bit block version of Rijndael, not AES) instead of MCRYPT_RIJNDAEL_128 (real AES) could help an attacker to create unknown havoc in the remote system. |
