| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
xen/gntalloc: validate grant count before allocation
gntalloc_ioctl_alloc() allocates the grant-id array before checking
whether the requested count fits within the global grant limit. Counts
above that limit cannot succeed, so reject them before the
user-controlled allocation reaches kcalloc().
Use a subtraction-based check while holding gref_mutex so adding the
requested count cannot wrap. Also cast the count before advancing the
per-file index so the page-size multiplication is performed in 64-bit
arithmetic. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: fix lease break and ack state handling
Do not skip valid lease states containing WRITE_CACHING when breaking
level-II/read leases for writes and truncates.
Handle lease break acknowledgments according to the SMB2 rule that the
acknowledged state must be a subset of the server's break target. Apply
the acknowledged state directly and keep the break pending on failed ACKs. |
| In the Linux kernel, the following vulnerability has been resolved:
mailbox: imx: Add a channel shutdown field
sashiko complained about possible teardown problem. The scenario
CPU 0 CPU 1
imx_mu_isr() imx_mu_shutdown()
imx_mu_xcr_rmw(priv, IMX_MU_RCR, 0, IMX_MU_xCR_RIEn(priv->dcfg->type, cp->idx));
imx_mu_specific_rx()
imx_mu_xcr_rmw(priv, IMX_MU_RCR, IMX_MU_xCR_RIEn(priv->dcfg->type, 0), 0);
free_irq()
The RX event remains enabled because in this short window the RX event
was disabled in ->shutdown() while the interrupt was active and then
enabled again by the ISR while ->shutdown waited in free_irq().
This race requires timing and if happens can be problematic on shared
handlers if the "removed" channel triggers an interrupt. In this case
the irq-core will shutdown the interrupt with the "nobody cared"
message.
Introduce imx_mu_con_priv::shutdown to signal that the channel is
shutting down. This flag is set with the lock held (by
imx_mu_xcr_clr_shut()). The unmask side uses imx_mu_xcr_set_act() which
only enables the event if the channel has not been shutdown and
serialises on the same lock. |
| Vitess is a database clustering system for horizontal scaling of MySQL. Prior to 23.0.5 and 24.0.2, twopczHandler in go/vt/vttablet/tabletserver/twopcz.go writes the Action and dtid form values from the vttablet and vtcombo /twopcz HTTP debug endpoint into a text/html response without HTML escaping. Under the default allow-all ACL policy, a remote unauthenticated attacker can send an operator a crafted request that executes script in the operator's browser after the request is opened. The script runs with the vttablet debug origin and can read same-origin diagnostic endpoints that expose query, transaction, environment, variable, or profiling data available in that deployment. This issue is fixed in versions 23.0.5 and 24.0.2. |
| Hugging Face Datasets through 5.1.0 contains an insecure deserialization vulnerability that allows attackers to execute arbitrary Python code by crafting a malicious pickle file loaded through the deprecated pandas packaged builder. Attackers can supply a pickle-backed dataset that is processed by Pandas._generate_tables via pandas.read_pickle() without validation, so when a victim calls datasets.load_dataset("pandas", data_files=...), the embedded __reduce__ payload executes code with the victim process's privileges. |
| Backstage is an open framework for building developer portals. Prior to 4.1.0, the @backstage/plugin-scaffolder-backend package is affected by incorrect authorization in scaffolder task listing. An authenticated internal user may be able to view metadata for scaffolder tasks outside the visibility intended by a deployment's permission policy. Stored task secrets are not included in the affected response, and no integrity or availability impact was identified. This issue is fixed in version 4.1.0. |
| Backstage is an open framework for building developer portals. Prior to 0.3.10 in @backstage/plugin-scaffolder-backend-module-bitbucket-cloud and 0.2.25 in @backstage/plugin-scaffolder-backend-module-bitbucket-server, the Bitbucket pull-request Scaffolder actions did not sufficiently validate filesystem paths. An authenticated user who can execute an eligible template and influence an allowed Bitbucket repository could affect paths outside the expected working area, potentially compromising backend confidentiality, integrity, or availability. This issue is fixed in @backstage/plugin-scaffolder-backend-module-bitbucket-cloud 0.3.10 and @backstage/plugin-scaffolder-backend-module-bitbucket-server 0.2.25. |
| In the Linux kernel, the following vulnerability has been resolved:
mailbox: imx: Use devm_pm_runtime_enable()
sashiko complained about early usage of the device while probe isn't
completed. This can be mitigated by delaying the pm_runtime_enable()
into the removal path instead doing it early. This ensures that in an
error case the device is removed (and imx_mu_shutdown()) before
pm_runtime_disable() so we don't have to do this manually.
For the order to work, lets move devm_mbox_controller_register() until
after the pm-runtime part. So the reverse order will be mbox-controller
removal followed by disabling pm runtime.
Use devm_pm_runtime_enable(), remove manual pm_runtime_disable()
invocations and move the pm_runtime handling in probe before
devm_mbox_controller_register(). |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: Properly acquire queue buffers in CRIU restore
When kfd_queue_acquire_buffers() was split off from
set_queue_properties_from_user(), set_queue_properties_from_criu()
was missed. Thus, set_queue_properties_from_criu() is not
filling out the buffer fields of queue_properties, which
can come up when subsequent code expects them to be non-null.
Add the proper call to kfd_queue_acquire_buffers(), and also
use the right cast types in set_queue_properties_from_criu()
(which were missed at the same time)
(cherry picked from commit 88ed96abbbe27b70193544fbc1ee06448c274714) |
| In the Linux kernel, the following vulnerability has been resolved:
namespace: don't let a pseudo dentry become the root of a mount
d_alloc_pseudo() hands out dentries for pipes, sockets and other files
that are never anyone's child or parent. They carry DCACHE_NORCU and
dentry_free() frees them right away because no lockless path walk can
ever reach them. That holds as long as such a dentry isn't the root of
a mount. But bind mounting /proc/self/fd/<fd> of such a file does
exactly that.
Most callers of alloc_file_pseudo() put their files on kernel-internal
mounts and may_copy_tree() refuses those. bpf_token_create() doesn't. It
places the token file on the bpffs mount the caller handed it and that
mount is in the caller's mount namespace so the clone goes through:
mount --bind /proc/self/fd/<token> <file>
open_tree(tokfd, "", AT_EMPTY_PATH | OPEN_TREE_CLONE) + move_mount()
__follow_mount_rcu() then loads ->mnt_root of that mount, reads d_seq
and d_flags of the dentry and only then checks mount_lock. The dentry
can be gone by then. The final mntput() of an unmounted parent unhooks
a child that stayed attached to it under mount_lock alone. When the
child's holder does the final put right after that the root is dput()
and freed immediately while a walker that found the mount hashed still
looks at it.
Refuse to clone a mount with a DCACHE_NORCU dentry as its root. Nothing
sensible can be done with a bind mount of a bpf token anyway. |
| In the Linux kernel, the following vulnerability has been resolved:
namespace: check the mounts before reading their parents in pivot_root()
path_pivot_root() reads the parents of new_root and of the caller's root
and checks whether they are shared before it checks that either mount is
in the caller's mount namespace. Only namespace_sem is held. That's fine
for a mount that is in the caller's mount namespace.
But new_root can be a file descriptor to a mount that has been unmounted
and that only the file descriptor keeps alive. If that mount stayed
attached to its parent when it was unmounted nothing pins the parent for
it. The final mntput() of the parent unhooks the children under
mount_lock alone and frees the parent afterwards:
pivot_root() close(fd), last ref on the parent
------------ ---------------------------------
ex_parent = new_mnt->mnt_parent
mntput_no_expire_slowpath()
__umount_mnt(new_mnt)
cleanup_mnt()
call_rcu()
IS_MNT_SHARED(ex_parent)
BUG: KASAN: slab-use-after-free in path_pivot_root+0xf1a/0x1840
Read of size 4 at addr ffff8881047382f8 by task pivot_widen/157
path_pivot_root+0xf1a/0x1840
__x64_sys_pivot_root+0x165/0x190
The same goes for the caller's root via chroot(). Both outcomes of the
check end in EINVAL so nothing but the read itself goes wrong. It's the
same thing commit bb4609405752 ("statmount: read the parent of an
unmounted mount under mount_lock") fixed for statmount().
Check that both mounts are in the caller's namespace before their
parents are read. Every path returns EINVAL either way. |
| A Signed to Unsigned Conversion Error vulnerability in the srxpfe of Juniper Networks Junos OS on the SRX Series allows an adjacent attacker to cause a denial of service of the data plane via chassis-cluster fabric traffic. |
| An Integer Underflow (Wrap or Wraparound) vulnerability in the rpd process of Juniper Networks Junos OS on EX Series and MX Series, and Junos OS Evolved on ACX Series allows an unauthenticated adjacent attacker to cause heap memory disclosure and multicast join-state injection via a malformed Rosen-MVPN message.
This issue only affects platforms that support draft Rosen MVPN, such as the ACX Series, EX Series, and MX Series. |
| Loop with Unreachable Exit Condition ('Infinite Loop') vulnerability in Erlang OTP stdlib (erl_tar module), hexpm hex_core (hex_erl_tar module), hexpm hex (mix_hex_erl_tar module) and erlang rebar3 (r3_hex_erl_tar module) allows an attacker who supplies a tar archive to cause a denial of service via a crafted GNU sparse member.
When erl_tar:extract/1,2 writes a member to disk, erl_tar:stream_to_file_loop/3 reads it in chunks of 65536 bytes by default. For a GNU sparse member whose sparse map ends before its real size, erl_tar:do_sparse_read/3 matches its trailing-hole clause before its zero-length clause. After the chunk is used up, the trailing-hole clause reads zero bytes, does not advance the position, and recurses forever. A 2048-byte archive keeps the extracting process and one scheduler busy until the process is killed. The {max_size, N} option prevents this only when N is below the real size of the member. Extraction with the memory option is not affected.
hex_core ships its own copy of erl_tar as hex_erl_tar, and Hex and rebar3 ship hex_core with prefixed module names (mix_hex_erl_tar and r3_hex_erl_tar). These copies contain the same code and do not call stdlib's erl_tar, so they are affected on any OTP version. OTP 28 is not affected, but an application running on OTP 28 is affected if it extracts archives through an affected version of hex_core, Hex or rebar3.
This issue affects OTP from OTP 29.0 before OTP 29.1.2, corresponding to rebar3 from 3.27.1 before 3.28.0, and stdlib from 8.0 before 8.1.1, and hex from 2.4.2 before 2.5.3; hex_core: from 0.14.0 before 0.20.1. |
| An Out-of-bounds Write vulnerability in the routing protocol daemon (rpd) of Juniper Networks Junos OS and Junos OS Evolved allows an eBGP peer which has not negotiated four-octet-AS capability sending a specifically malformed BGP update to cause a Denial-of-Service (DoS). |
| F´ (F Prime) is a framework that enables development and deployment of spaceflight and other embedded software applications. Prior to 4.2.0, Fw::FilePacket deserialization used by Svc::FileUplink is vulnerable because Header deserialization casts the byte to the Type enum without validating its range and FilePacket::fromSerialBuffer reaches a default FW_ASSERT. When a network file packet contains an unknown file-packet type byte, the assertion aborts or resets the default Ref application process, causing denial of service. This issue is fixed in version 4.2.0. |
| A flaw was found in evolution-data-server. Calendar events containing a file:// URI in their ATTACH property automatically read the targeted local file, base64-encode its contents and upload it back to the server when the event is saved. There are no file path restrictions or checks to verify whether the attachment originally came from the server or was added locally. This allows an attacker with access to a shared CalDAV calendar to exfiltrate arbitrary files the user has access to when interacting with malicious calendar events. |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in hippooo Hippoo Mobile App for WooCommerce hippoo allows Reflected XSS.This issue affects Hippoo Mobile App for WooCommerce: from n/a through 1.12.0. |
| A stored cross-site scripting (XSS) vulnerability in Palo Alto Networks PAN-OS® software enables a malicious authenticated administrator to store or execute a JavaScript payload using the web interface.
The security risk posed by this issue is minimized when the management interface is restricted to only trusted internal IP addresses according to our recommended best practice deployment guidelines https://live.paloaltonetworks.com/t5/community-blogs/tips-amp-tricks-how-to-secure-the-management-access-of-your-palo/ba-p/464431 .
This issue is applicable to PAN-OS® software on PA-Series and VM-Series firewalls and on Panorama (virtual and M-Series).
Cloud NGFW and Prisma® Access are not affected by these vulnerabilities. |
| When the HTTP stream wrapper follows a redirect and the response carries a Location header with an empty value, the redirect code reads one byte past the end of the heap buffer holding the location. The value of that out-of-bounds byte decides which redirect target is built, so a malicious server controls whether the client is sent to the host root or to the current directory. |
