| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
usb: typec: tcpm: recover after failure to start the frs ams
Reset the port if the tcpm fails to start the FAST_ROLE_SWAP AMS by
initiating error recovery on it.
This helps in cases where some cables (incorrectly) signal an FRS to
an FRS capable port during disconnection. The TCPC autonomously starts
sourcing VBUS on detecting the FRS signal. However, the VBUS sourcing is
left on when the FAST_ROLE_SWAP AMS fails to start (as tcpm_sink_tx_ok
is 0 as CC is open due to the cable disconnect). This is because the
code sets the state to INVALID_STATE without resetting the port state.
Log snippet before changes:
[ 101.401960] AMS FAST_ROLE_SWAP start
[ 101.401971] Sink TX No Go
[ 101.401982] sourcing vbus
[ 101.401987] VBUS on
[ 101.402159] VBUS on
[ 109.257809] CC1: 0 -> 0, CC2: 5 -> 0 [state SNK_READY, polarity 1, disconnected]
[ 111.267442] VBUS on
After changes:
[ 70.541211] AMS FAST_ROLE_SWAP start
[ 70.541220] Sink TX No Go
[ 70.541228] state change SNK_READY -> ERROR_RECOVERY [rev3 NONE_AMS]
[ 70.541362] VBUS on
[ 70.541365] sourcing vbus
[ 70.541367] VBUS on
[ 70.541374] state change ERROR_RECOVERY -> PORT_RESET [rev3 NONE_AMS]
[ 70.541410] disable vbus discharge ret:0
[ 70.543028] Setting usb_comm capable false
[ 70.544009] Setting voltage/current limit 0 mV 0 mA
[ 70.544034] polarity 0
[ 70.544239] Requesting mux state 0, usb-role 0, orientation 0
[ 70.555550] cc:=0
[ 70.555595] pending state change PORT_RESET -> PORT_RESET_WAIT_OFF @ 100 ms [rev3 NONE_AMS]
[ 70.555697] VBUS off
[ 70.555702] VBUS VSAFE0V
[ 70.555762] CC1: 5 -> 0, CC2: 0 -> 0 [state PORT_RESET, polarity 0, disconnected]
[ 70.587794] VBUS off
[ 70.587799] VBUS VSAFE0V
[ 70.655672] state change PORT_RESET -> PORT_RESET_WAIT_OFF [delayed 100 ms]
[ 70.655682] state change PORT_RESET_WAIT_OFF -> SNK_UNATTACHED [rev3 NONE_AMS]
[ 70.655686] Start toggling
[ 70.656274] CC1: 0 -> 0, CC2: 0 -> 0 [state TOGGLING, polarity 0, disconnected] |
| In the Linux kernel, the following vulnerability has been resolved:
usb: core: clear both ep_in and ep_out for non-ep0 control endpoints
In usb_enable_endpoint(), non-zero control endpoints (where
usb_endpoint_xfer_control(&ep->desc) is true) populate both
dev->ep_in[epnum] and dev->ep_out[epnum] with the same struct
usb_host_endpoint pointer.
However, usb_disable_endpoint() only clears either dev->ep_out[epnum] or
dev->ep_in[epnum] depending on the direction bit of epaddr when
reset_hardware is set, leaving the opposite direction's array slot
pointing to the disabled/freed endpoint.
Clear both dev->ep_out[epnum] and dev->ep_in[epnum] when disabling a
non-ep0 control endpoint with reset_hardware set, and update the
function kerneldoc accordingly.
Tested in QEMU against Linux 7.3.0-rc3 using dummy_hcd and raw-gadget to
enumerate a USB device with a non-zero control endpoint
(bEndpointAddress 0x01, bmAttributes USB_ENDPOINT_XFER_CONTROL),
verifying that both dev->ep_in[1] and dev->ep_out[1] are cleared when
the interface is disabled. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: dwc3: gadget: fix IRQ storm on invalid event buffer count
When dwc3_check_event_buf() reads a GEVNTCOUNT value exceeding the
event buffer length, commit 63ccd26cd1f6 ("usb: dwc3: gadget: check
that event count does not exceed event buffer length") returns IRQ_NONE
without writing back GEVNTCOUNT. Since the DWC3 interrupt is
level-triggered, the uncleared IRQ source keeps the line asserted,
causing a tight IRQ storm that accumulates 99,900 unhandled interrupts
and triggers spurious.c:184 BUG -> kernel panic.
The resulting call stack:
__report_bad_irq+0xac/0xc8
note_interrupt+0x340/0x468
handle_irq_event+0xac/0xc0
handle_fasteoi_irq+0x120/0x228
gic_handle_irq+0x68/0x108
...
kernel BUG at kernel/irq/spurious.c:184
To reproduce, write a bogus value exceeding the event buffer length
directly to the GEVNTCOUNT register:
devmem <DWC3_BASE + 0xc40c> 4 0x1004
Write the bogus count back to GEVNTCOUNT to clear the IRQ source,
consistent with the stale event clearing pattern in
dwc3_event_buffers_setup(), and schedule error recovery to
reinitialize the controller. |
| Vulnerability in Oracle Essbase (component: Security). The supported version that is affected is 21.8.3.0.0. Difficult to exploit vulnerability allows unauthenticated attacker with network access via TCP to compromise Oracle Essbase. Successful attacks of this vulnerability can result in takeover of Oracle Essbase. CVSS 3.1 Base Score 8.1 (Confidentiality, Integrity and Availability impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:H/PR:N/UI:N/S:U/C:H/I:H/A:H). |
| VeloCloud Orchestrator (VCO) on-prem has a security issue where this issue may allow a remote attacker to access privileged internal functionality and impact the VCO host. Successful exploitation may compromise the confidentiality, integrity, and availability of the orchestrator and data managed by the orchestrator.
On an affected system, any authenticated user can gain operator privileges and masquerade as a local "superuser operator" user. This includes access to functionality that is intended for internal use only and which is not intended to be remotely accessible.
Hosted, including Dedicated, versions of VCO were impacted and have already been patched. |
| Untrusted pointer dereference in DNS Server allows an unauthorized attacker to execute code over a network. |
| Untrusted pointer dereference in DNS Server allows an unauthorized attacker to execute code over a network. |
| Untrusted pointer dereference in DNS Server allows an unauthorized attacker to execute code over a network. |
| Out-of-bounds read in Windows Cryptographic Services allows an authorized attacker to disclose information locally. |
| Out-of-bounds read in Microsoft Office PowerPoint allows an unauthorized attacker to disclose information over a network. |
| Buffer over-read in Microsoft Office Excel allows an unauthorized attacker to disclose information over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/xe/i2c: cancel the client work on remove
xe_i2c_notifier() stores the DesignWare adapter in i2c->adapter and
schedules i2c->work when the adapter is registered under the xe I2C
platform device, and xe_i2c_client_work() then instantiates the AMC
client device on that adapter.
xe_i2c_remove() tears down the AMC, unregisters the client devices,
the bus notifier and the adapter platform device, but it never drains
i2c->work. A work item that is still queued or running when the
adapter is unregistered dereferences i2c->adapter in
i2c_new_client_device() after platform_device_unregister() has
released the adapter. The work item is also embedded in the
devm-allocated struct xe_i2c, so a work item still queued after the
drm device devm unwind frees that allocation runs its callback on
freed memory.
The bus notifier is the only thing that schedules this work, and it is
unregistered after the client devices. An instance that is still queued
when the teardown runs can therefore write
i2c->client[XE_I2C_CLIENT_AMC] while the loop is unregistering and
clearing the same array, and an AMC client it instantiates late is only
cleaned up by the adapter's own child sweep in i2c_del_adapter().
Move bus_unregister_notifier() in front of the client teardown loop
and cancel the work right after it, so no new instance can be
scheduled and a queued instance is drained before the client array is
touched. A running instance still finds a live adapter, since the
adapter is unregistered later.
(cherry picked from commit a23f27d5ec11c3f418c5e5531eea34ccda2b5b20) |
| Time-of-check time-of-use (toctou) race condition in Windows Modern Device Management (MDM) allows an authorized attacker to elevate privileges locally. |
| Baserow versions 2.2.0 through 2.3.3 contain an SQL injection vulnerability in the index() formula function. A low-privileged authenticated user who can create or modify Formula fields can provide an undocumented fourth argument that is treated as a SQL template and interpolated directly into a PostgreSQL expression. The generated SQL executes through Baserow's database connection with the Baserow PostgreSQL role permissions, allowing data outside the user's workspace permissions to be read or modified. |
| Trudesk through 1.2.11 contains a missing authentication vulnerability that allows unauthenticated attackers to download private ticket attachments under /uploads. Because express.static serves the public/ directory before the hasAuth-guarded /uploads mount, attackers who know or guess a ticket ObjectId and filename can retrieve confidential attachments. |
| 10up Distributor before 2.3.2 contains a PHP object injection vulnerability that allows Contributor-level users to instantiate PHP objects by double unserializing distributed post meta. Attackers can store a serialized PHP string as meta, which set_meta() in includes/utils.php unserializes on the destination site, storing attacker-defined objects whose impact depends on loaded gadget classes. |
| Xiaozhi-esp32-server-java through 6.1.0 contains an authentication bypass vulnerability that allows unauthenticated attackers to obtain valid device WebSocket tokens by requesting /api/device/ota with any MAC address. Attackers can open a victim device's WebSocket channel to read private role system prompts, write conversation history, consume LLM/STT/TTS credentials, and overwrite device metadata. |
| CoAI (Chat Nio) through 4.0.0 contains an unauthenticated path traversal vulnerability in the generation and article archive download endpoints via the hash query parameter. Attackers can supply ../ sequences in hash to download any readable .tar.gz or .zip file, including other users' generated archives. |
| AllData through 0.7.1 contains an unauthenticated JDBC injection vulnerability that allows remote attackers to open arbitrary database connections by supplying jdbcUrl and jdbcDriverClass values to the data-dts /jobJdbcDatasource/test endpoint. Attackers can supply a MySQL JDBC URL with allowLoadLocalInfile=true pointing to an attacker-controlled server to read arbitrary files from the data-dts host. |
| Jeepay through 3.2.9 contains an insecure direct object reference vulnerability that allows authenticated merchant users to delete other merchants' division receivers by exploiting an ownership check on the wrong column. Attackers holding ENT_DIVISION_RECEIVER_DELETE who own a receiver group whose id matches a victim's receiver id can delete the victim's profit-sharing receiver. |
