| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: use check_add_overflow for shader size+offset bound
vmw_shader_define() validates the user-supplied shader window against
its backing buffer with
(u64)buffer->tbo.base.size < (u64)size + (u64)offset
drm_vmw_shader_create_arg::offset is __u64 in the uapi; when it is
near U64_MAX the unsigned addition wraps and the resulting tiny value
passes the check. The unbounded offset is then stored in
res->guest_memory_offset and forwarded to host SVGA shader-create
commands.
Use check_add_overflow() to detect the wrap and compare the resulting
endpoint against the buffer size. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: pci: Validate AIBV and AISB before pinning guest pages
The AIBV holds one bit per MSI-X vector for a given function. The size of
the bit vector is derived from the NOI and the AIBVO. If the size of the
AIBV exceeds a single page boundary, then reject the request as we cannot
safely pin the guest AIBV.
Similarly reject the request if the AISB address is not 8-byte aligned as
the architecture requires doubleword alignment for the summary bit address.
Since the AISBO can address up to 64 bits, the size of the AISB can only be
8 bytes for the function. This also ensures the AISB doesn't exceed a
single page boundary. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: SDCA: Make UMP message size check more robust
If message offset was larger than the buffer length the size
check will pass incorrectly. Refactor the check such that it is
more robust to invalid sizes. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: codecs: lpass-wsa-macro: Fix enum kcontrol accesses
EAR SPKR PA Gain" and the four "WSA RX* Mux" controls are enumerated,
but their get and put callbacks access the value through
ucontrol->value.integer.value[0] (a long) instead of
ucontrol->value.enumerated.item[0] (an unsigned int).
This same pattern was fixed in the sibling drivers by
commit bcfe5f76cc40 ("ASoC: codecs: rx-macro: fix accessing array
out of bounds for enum type") and
commit 0ea5eff7c606 ("ASoC: codecs: va-macro: fix accessing array
out of bounds for enum type"), but wsa-macro was missed.
On 64-bit kernels with CONFIG_SND_CTL_DEBUG this trips the elem value
sanity check and every read of these controls fails with -EINVAL. |
| An issue in the NetStaX EtherNet/IP Stack prior to v5.6.1 could allow a large Class 3 explicit-message request to exceed the application-side receive buffer without generating an error or warning. The result could be memory corruption, a device crash, or a potential remote attack vector without the originating device receiving a CIP error indicating that the request could not be processed. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: qce - fix CCM AAD buffer underallocation
The AAD buffer allocated in qce_aead_ccm_prepare_buf_assoclen()
can be smaller than the length later programmed into the DMA
scatterlist.
The allocation size is currently calculated as:
ALIGN(assoclen, 16) + MAX_CCM_ADATA_HEADER_LEN
while the DMA length is set to:
ALIGN(assoclen + adata_header_len, 16)
Since ALIGN() does not distribute over addition, the allocation
can be smaller than the DMA length. For example, when
assoclen = 32 and adata_header_len = 2:
allocation = ALIGN(32, 16) + 6 = 38
DMA length = ALIGN(32 + 2, 16) = 48
As a result, the QCE hardware can read beyond the allocated
buffer while computing the CBC-MAC over the associated data.
The extra bytes are folded into the authentication tag,
resulting in an incorrect tag and causing CCM self-test
failures such as:
alg: aead: ccm-aes-qce encryption test failed (wrong result)
on test vector 8
Fix the allocation by adding the maximum possible AAD header
length before alignment:
ALIGN(assoclen + MAX_CCM_ADATA_HEADER_LEN, 16)
This guarantees that the allocated buffer is large enough
for the fully padded AAD data for all supported header sizes. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs3: Allocate iomap inline_data using alloc_page
This fixes a BUG reported in iomap_write_end_inline:
iomap_inline_data_valid checks that the inline_data fits within
a page. If the inline_data is allocated with kmemdup there's no
guarantee that it's page-aligned, so the check sometimes fails.
Allocate it with alloc_page to ensure it's page-aligned. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: hid-goodix-spi: validate report size to prevent stack buffer overflow
goodix_hid_set_raw_report() builds a protocol frame in a 128-byte stack
buffer (tmp_buf), writing an 11-12 byte header followed by the
caller-supplied report data. The HID core caps report size at
HID_MAX_BUFFER_SIZE (16384) by default, while the driver does not set
hid_ll_driver.max_buffer_size and performs no bounds checking before
copying the payload:
memcpy(tmp_buf + tx_len, buf, len);
A hidraw SET_REPORT ioctl with a report larger than ~116 bytes
overflows the stack buffer.
Add a size check after constructing the header, rejecting reports that
would exceed the buffer capacity.
Discovered by Atuin - Automated Vulnerability Discovery Engine. |
| CVE-2026-55400 is an integer underflow in Secure Access servers prior to
version 14.57. Attackers with an authenticated session can send
specially crafted traffic to a server in a non-default configuration and
cause a persistent denial of service. |
| CVE-2026-55402 is an out of bounds read vulnerability in Secure Access
servers prior to version 14.57. Attackers with an ‘in the middle’
position can send specially crafted data to a server causing a
persistent denial of service. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: Fix UVD dpb min size calculation for H264
This should use actual number of references from the decode
message, instead of maximum derived from level.
(cherry picked from commit 64b525edb7e7bdfcdc77883c5e413804e2396856) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: Reject UVD message with dimensions above 4096
Fixes potential overflow in DPB size calculations.
(cherry picked from commit 05e1387d151f71569fbe122d2c89f9db0c21dc10) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: Reject UVD message with invalid number of h265 refs
Same change as for h264, avoids overflow later when calculating
min dpb size.
(cherry picked from commit a4b0720e4f1601f97f59a2be9c1b4b94fa6527d5) |
| FreeIPMI before 1.6.19 has a stack-based buffer overflow in _ipmi_sel_oem_fujitsu_get_sel_entry_long_text in libfreeipmi/sel/ipmi-sel-string-fujitsu-irmc-common.c via malformed Fujitsu SEL long-text responses. |
| XING CPTrans-ME-X contains a Use of Default Password (CWE-1393). Anyone with the knowledge of the credential may log in to the affected device. |
| A heap overflow in SMM module may allow an attacker with access to a second vulnerability that enables writing to SPI flash, potentially resulting in arbitrary code execution. |
| In Reactor Core, applications that use the Flux.windowTimeout operator with fairBackpressure enabled are vulnerable to a Denial of Service (DoS) condition.
Reactor Core 3.8.0 - 3.8.6
Reactor Core 3.5.0 - 3.7.19
Reactor Core 3.4.41 and earlier |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: bound the attribute-list entry in ntfs_read_inode_mount()
The $MFT attribute-list walk in ntfs_read_inode_mount() validates each
entry only with "(u8 *)al_entry + 6 > al_end" and
"(u8 *)al_entry + le16_to_cpu(al_entry->length) > al_end", but then reads
al_entry->lowest_vcn (an __le64 at offset 8) and al_entry->mft_reference
(offset 16) -- fields beyond the 6 bytes proven in range. al_entry->length
is attacker-controlled and only required non-zero, so a short entry (e.g.
length 8) placed at the tail passes both checks while the lowest_vcn /
mft_reference reads fall past al_end.
al_end is ni->attr_list + attr_list_size (the on-disk size); the buffer is
kvzalloc(round_up(attr_list_size, SECTOR_SIZE)), so the sector rounding
usually absorbs the over-read -- but when attr_list_size is a multiple of
SECTOR_SIZE there is no slack and a crafted $MFT attribute list produces an
out-of-bounds read at mount time.
Validate the entry with ntfs_attr_list_entry_is_valid() (added in patch
1/3) before dereferencing it, matching the bound the other attribute-list
walks now use. The validator already requires the length to cover the fixed
header, which makes the separate "!al_entry->length" check redundant, so
drop it too. |
| In the Linux kernel, the following vulnerability has been resolved:
arm64: dts: renesas: ironhide: Describe inline ECC carveouts
The DBSC5 DRAM controller protects DRAM content using inline ECC.
The inline ECC utilizes areas of DRAM for its operation, which are
in the DRAM address range, but must not be accessed or modified.
Describe the inline ECC carveout areas used by the DBSC5 controller
on this hardware as reserved-memory, which must not be accessed.
Include DRAM areas which are unprotected by ECC as well, those are
parts of the DRAM which directly precede the ECC carveout.
In case of high DRAM utilization, unless the inline ECC carveouts
are properly reserved, Linux may use and corrupt the memory used
by the DBSC5 DRAM controller for inline ECC, which would lead to
the system becoming unstable. |
| A maliciously crafted input, when processed by the Autodesk Installer IPC frame parser, may trigger improper validation of an input-specified position or offset, resulting in an out-of-range substring operation. A malicious actor may leverage this vulnerability to cause the NT AUTHORITY\SYSTEM service to terminate unexpectedly, resulting in a denial-of-service condition. |
